## Enables the older HWRF 43-level vertical structure.
#
# Enables 2013 HWRF-WPAC vertical structure and disable GSI.  GSI
# cannot run with this vertical structure because the model top is too
# low.  Also enables a smaller timestep, and changes ntrack to match.
# Note that this is exactly the same as hwrf_other_basins.conf, except
# that this file retains ocean coupling.
#
# @note If you also use the hwrf_3km.conf, you must load this file first.

[prelaunch]
hwrf_43lev_conf=yes       ;; Indicate hwrf_43lev.conf was loaded
last_of_43lev_3km=43lev   ;; Used to detect loading this file after hwrf_3km.conf

[config]
run_gsi=no   ;; cannot run GSI with this vertical structure
run_ensemble_da=no ;; Disable ENSDA since GSI is disabled

[wrf]
ptop=5000   ;; Lower model top: 50 mbar
ptsgm=20000 ;; This value used in 2013 in WP, IO basins.

## Smaller model timestep: 33+3/4 seconds.
#
# Some storms need a smaller timestep for model stability when running
# at 2km.  This timestep is NOT compatible with the ntrack values set
# in the hwrf_3km.conf, so you MUST load the hwrf_3km.conf later than
# this file to ensure the timestep is 45 seconds.
dt = 33+3/4

[namelist_outer]
physics.ntrack = 8

[namelist_inner]
physics.ntrack = 16

[moad_namelist]
physics.ntrack = 8

[wrf_namelist]
domains.eta_levels=1.0, 0.9919699, 0.9827400, 0.9710800, 0.9600599, 0.9462600, 0.9306099, 0.9129300, 0.8930600, 0.8708600, 0.8462000, 0.8190300, 0.7893100, 0.7570800, 0.7224600, 0.6856500, 0.6469100, 0.6066099, 0.5651600, 0.5230500, 0.4807700, 0.4388600, 0.3978000, 0.3580500, 0.3200099, 0.2840100, 0.2502900, 0.2190100, 0.1902600, 0.1640600, 0.1403600, 0.1190600, 0.1000500, 0.0831600, 0.0682400, 0.0551200, 0.0436200, 0.0335700, 0.0248200, 0.0172200, 0.0106300, 0.0049200, 0.0000000